Chapter 2 Hardware Installation Page 18
Figure 4 Interface Definition
RS-232
RS-232, which is labeled COM/RESET, is used for debugging purposes as well as for hard reset of the
SGT-LD-55-23. Below you may find the pin definition of the RS-232.
Table 1 PIN Definition
To reset the device, short P7 (Hard Reset) to P8 (GND) for less than 1 second and the system will
reset. If P7 (Hard Reset) is shorted to P8 (GND) for over 5 seconds, the SGT-LD-55-23 LD will be
reset to the factory default settings.
Comments to this Manuals